-------- -------- --------

Ideal for use on cooling/heating coils on tanks and vessels, and various other forms of heat exchange surfaces such as plate-to-plate, coil-to-coil, tubing-to-plate, expansion valves, etc. This product should be used where frequent removal is necessary. These non-hardening mastics have high thermal expansion, thus allowing them to maintain excellent surface contact during expansion and contraction cycles.
Application: Apply a thin layer approximately 1/8" thick, just enough to give good contact between surfaces. Application can be done by hand trowel, pumps or caulking gun. If application will be done by any type of extrusion method, please mention when placing an order. No mixing necessary.
Curing: None required.
Minimum temperature for application: 5°F
Maximum usage temperature limits: 300°F (150°C)
Minimum usage temperature limits: -116°F (-80°C)
Thermal conductivity: 40-50 BTU in/hr/sq. ft°F
U range: 20-40 BTU/hr/sq. ft°F
Shelf life: 3-5 years
Net weight: 12 lbs/gal.
Soluble: No
Harmful vapors: None
Bonding strength: N/A
Usable life of product: Indefinite; will perform for the life of the installation.
Typically a stock item

Application based on cements applied at 1/8 inch thickness are approximately:

12 sq. ft per gallon on clamp-on coils
No minimum orders
Product sold in 1, 5, and 55 gallon cans, also quarts and pints upon special request.

Please contact us for MSDS requests.

Phone: (800) 804-4596 | Fax: (302) 328-0261 | sales@chemaxcorp.com

Please dial (302) 328-2440 if calling from outside the US

-----------------