-------- -------- --------
- Originally designed for use on externally heated/cooled tanks and vessels. Other uses include heat exchanged surfaces, clamp-on coils, instrumentation temperature control, electrical heating tape, and aluminum surfaces. Can be easily removed and will withstand expansion and contraction cycles.
- Application: By hand trowel or pumping methods. Surface does not have to be rust free. However, previously corroded surfaces should be evaluated before applying TRACIT cements. Once applied, these non-hardening mastics act as a corrosive barrier. Cement can be warmed to 75°F for easier application. Apply a layer approximately 1/8" thick. When used on plate coils, excess will ooze out sides while leaving a coating between coil and tank to fill air voids.
- Curing: None required.
- Minimum temperature for application: 5°F
- Maximum usage temperature limits: 375°F (191°C)
- Minimum usage temperature limits: -116°F (-80°C)
- Thermal conductivity: 45-55 BTU in/hr/sq. ft°F
- U range: 20-40 BTU/hr sq. ft°F
- Shelf life: 3-5 years
- Net weight: 12 lbs/gal.
- Soluble: No
- Harmful vapors: None
- Bonding strength: N/A
- Usable life of product: Indefinite; will perform for the life of the installation.
- Typically a stock item
- Tracit-1100A should be requested when application is being done by pump.
COVERAGE RATES:
Application based on cements applied at 1/8 inch thickness are approximately:
- 12 sq. ft per gallon on clamp-on coils
- No minimum orders
- Product sold in 1, 5, and 55 gallon cans, also quarts and pints upon special request.
Please contact us for MSDS requests.
Phone: (800) 804-4596 | Fax: (302) 328-0261 | sales@chemaxcorp.com
Please dial (302) 328-2440 if calling from outside the US
