-------- -------- --------
- Ideal for use on tracers attached to pipes. Also for valves, elbows, or anywhere there is a desire to maintain temperatures above and below ambient.
- Application: No mixing necessary, ready to use from the can. Spread a thin layer approximately 1/8" thick with a hand trowel to completely cover tracer (not entire pipe). It is optimal to remove loose paint, rust, scale, grease, etc. with wire brush before applying Tracit.
- Curing: Once Tracit is applied, curing may be expedited by applying heat up to 200°F when necessary. Otherwise, allow mastic to air-dry 24-48 hours or until completely hard before heating above 200°F. Do not heat hot enough to form steam during drying or to cause Tracit to boil, as this could cause cement to become porous and give poor heat transfer.
- Minimum temperature for application: 32°F
- Maximum usage temperature limits: 750°F (400°C)
- Minimum usage temperature limits: -300°F (-182°C)
- Thermal conductivity: 90 BTU in/hr sq. ft degrees F
- U range: 20-40 BTU/hr sq. ft degrees F
- Container sizes: 1 gal., 5 gal., and quart cans
- Shelf life: 1-2 years from date of manufacture in airtight container.
- Weight: 15 lbs/gal.
- Soluble: Yes
- Harmful vapors: None
- Bonding strength: 200-275 lbs sq. in
- Can be used with or without Chemax galvanized covers.
- Typically a stock item
- Tracit-300WW should be requested when thinner viscosity is required.
COVERAGE RATES:
Application based on cements applied at 1/8 inch thickness are approximately:
- 12 sq. ft per gallon on clamp-on coils
- Tracing-Applied by hand troweling
-3/8" O.D. tubing-32 linear ft/gal.
-1/2" O.D. tubing-28 linear ft/gal. - No minimum orders
- Product sold in 1 and 5 gallon cans, also quarts and pints upon special request.
Please contact us for MSDS requests.
Phone: (800) 804-4596 | Fax: (302) 328-0261 | sales@chemaxcorp.com
Please dial (302) 328-2440 if calling from outside the US
